Dual Head System
The Dual Head System from Kern Lasers was designed especially for customers that wish to increase their cutting production. The
KCAM software will control both lasers
separately so the output powers can be matched.
The slave laser connects to the master laser
via an adjustable bar. Remove the bar and the
slave laser can be locked to the far right of the
gantry leaving the master laser full use of the
laser table.
The DHS laser offers a rugged table structure that will hold up to your demanding production schedules. The tight footprint of this model allows a 0" reach clearance for loading your material and removing your parts. Kern's DHS Laser Cutting and Engraving Systems use only one mirror, allowing easy adjustment of the laser beam to the optics lens. This adjustment is done once at the factory and may not need to be adjusted again. The DHS laser maintains a constant laser power over the entire table top as the laser is moved over the material with a fixed focus point.
![]() |
Cutting speeds are determined by the laser size, material being cut and the desired edge quality. Straight line cutting will be faster than small intricate cut patterns. Typical cutting speeds are from 6"/minute up to 600"/minute. Set the cutting speed and the laser power by line colors in our KCAM software to control the speed and depth of the cut.
The 7" deep vacuum table along with the aluminum honeycomb tabletop will exhaust smoke and debris from the cut material. All standard full gantry systems have a top vacuum located on the safety shield mounted around the laser nozzle to exhaust the smoke and fumes while engraving. Each laser cutter or laser engraving system is supplied with a vacuum blower to exhaust the fumes and smoke from the vacuum table chamber to the outside or through a customer supplied filter system.
If you are cutting production parts, this is the perfect laser system for you!






